NAT Port forwarding will nicht

[srxx]

Hallo,

ich habe auf einem W2008 Host einen W2003 Guest via NAT angebunden. Um den auch von aus erreichen zu können, habe ich Port forwarding aktiviert:

Host:8100 -> Guest:80

Rufe ich im Host http://localhost:8100 auf, wird mir korrekterweise der Webserver des Gastes angesprochen. Mache ich das von außerhalb des Hosts, gibt es keine Verbindung.

W2008 Inbound Rule auf 8100 hab ich gesetzt, Firewall abschalten hilft auch nicht.

Wie bekomme ich das an den Start? Danke.

[continuum]

poste mal die vmnetnat.conf

was passiert wenn du von aussen den port 8100 mit telnet ansprichst ?

[srxx]

# Windows NAT configuration file

[host]

# NAT gateway address
ip = 192.168.140.1/24
hostMAC = 00:50:56:C0:00:08

# enable configuration; disabled by default for security reasons
#configport = 33445

# VMnet device if not specified on command line
device = vmnet8

# Allow PORT/EPRT FTP commands (they need incoming TCP stream...)
activeFTP = 1

# Allows the source to have any OUI. Turn this one if you change the OUI
# in the MAC address of your virtual machines.
allowAnyOUI = 1

[udp]
# Timeout in seconds, 0 = no timeout, default = 30; real value might
# be up to 100% longer
timeout = 30

[dns]
# This section applies only to Windows.
#
# Policy to use for DNS forwarding. Accepted values include order,
# rotate, burst.
#
# order: send one DNS request at a time in order of the name servers
# rotate: send one DNS request at a time, rotate through the DNS servers
# burst: send to three servers and wait for the first one to respond
policy = order

# Timeout in seconds before retrying DNS request.
timeout = 2

# Retries before giving up on DNS request
retries = 3

# Automatically detect the DNS servers (not supported in Windows NT)
autodetect = 1

# List of DNS servers to use. Up to three may be specified
#nameserver1 = 198.41.0.4
#nameserver2 = 192.36.148.17
#nameserver3 = 202.12.27.33

[netbios]
# This section applies only to Windows.

# Timeout for NBNS queries.
nbnsTimeout = 2

# Number of retries for each NBNS query.
nbnsRetries = 3

# Timeout for NBDS queries.
nbdsTimeout = 3

[incomingtcp]
# Use these with care - anyone can enter into your virtual machine through these...

# FTP (both active and passive FTP is always enabled)
# ftp localhost 8887
#8887 = 192.168.27.128:21

# WEB (make sure that if you are using named webhosting, names point to
# your host, not to guest... And if you are forwarding port other
# than 80 make sure that your server copes with mismatched port
# number in Host: header)
# lynx http://localhost:8888
#8888 = 192.168.27.128:80

# SSH
# ssh -p 8889 root@localhost
#8889 = 192.168.27.128:22

8100 = 192.168.140.128:80
[incomingudp]
# UDP port forwarding example
#6000 = 192.168.27.128:6001

[PrivilegedTCP]
autodetect = 1

[PrivilegedUDP]
autodetect = 1


Von extern ist 8100 auch über Telnet tot.